To create a NAT on IPC and add to VPN network 10.0.38.0
Create a user
38 via VPN > Authentication This user doesn’t require specific
routers or other config.
Create a route via Network > Routing.
Source Network field can be left empty
Destitionat network =
OpenVPN USER =
Enabled checkbox is checked
The IPC has a LAN and a WAN side.
In this sample ETH1 is the WAN side and ETH0 is LAN. Following configuration /etc/network/interfaces
auto eth1 allow-hotplug eth1 iface eth1 inet dhcp
auto eth0 allow-hotplug eth0 iface eth0 inet static address 10.0.38.1 netmask 255.255.255.0
Configure OpenVPN to connect to Endian router with the user you made earlier
Configure IPtabels as described in this article: